2005-2008 RAV4 · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

  1. C117496
    Hold the front differential pinion to the front differential case side. Using a dial indicator, measure the backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    If the backlash is out of the specification, install proper side gear thrust washers.


INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER

  1. C068517
    Using a micrometer, measure the thickness of the thrust washer.

    Minimum thickness:
    0.54 to 0.66 mm (0.0213 to 0.0260 in.)

    If the thickness is less than the minimum, replace the front differential pinion thrust washer.


INSPECT NO.1 FRONT DIFFERENTIAL PINION SHAFT

  1. C068518
    Using a micrometer, measure the diameter of the pinion shaft.

    Minimum diameter:
    20.499 to 20.520 mm (0.8070 to 0.8079 in.)

    If the diameter is less than the minimum, replace the No. 1 front differential pinion shaft.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →