2005-2008 RAV4 · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

HINT:
Use these procedures to troubleshoot the audio and visual system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.BASIC INSPECTION
    1. Turn the ignition switch on (ACC).

    2. Check whether or not the display appears on the radio receiver.

      Result 
      Result
      Proceed to
      Display appears
      A
      Display does not appear
      B


    B.
    A

    4.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output.

    2. Delete the DTCs.

    3. Recheck for DTCs. Based on the DTC output in the first step, try to force output of the audio system DTC by simulating the operation indicated by the DTC.

      HINT:
      1. If the system cannot enter diagnostic mode, inspect each AVC-LAN communication signal and repair or replace problem parts.
      2. Even if the malfunction symptom is not confirmed, check for DTCs, as the system stores past DTCs.
      3. Refer to the detailed description on the diagnostic screen as necessary (Click here).
      4. Check and clear past diagnostic trouble codes. Check the diagnostic trouble code and inspect the area the code indicates.

    4. Result 
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B

    B.
    A

    5.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)

    2. Inspect front No. 1 speaker (Click here)

    3. Inspect rear speaker (Click here)

    4. Inspect steering pad switch (Click here)

    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      ← HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2005 – Jul 2008)IDENTIFICATION OF NOISE SOURCE (from Nov 2005) →