HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Nov 2005 – Jul 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
- HINT:
- Use these procedures to troubleshoot the audio and visual system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
Turn the ignition switch on (ACC).
Check whether or not the display appears on the radio receiver.
Result
Result
|
Proceed to
|
Display appears
|
A
|
Display does not appear
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Result
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here)
Inspect front No. 1 speaker (Click here)
Inspect rear No.1 speaker (Click here)
Inspect steering pad switch (Click here)
| NEXT |
|
 |
|
|
| 6.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|