2005-2008 RAV4 · Service Manual ENGINE

P0516 Battery Temperature Sensor Circuit Low

Diagnostic trouble codes · Vehicles built Jan 2007 – Jul 2007

Also covers:

Versions by build date: Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

The battery current sensor is installed on the battery negative terminal to detect battery temperature.
A thermistor is integrated into the battery current sensor, and the resistance of the thermistor in the battery current sensor changes according to the battery temperature.
The resistance of the thermistor in the battery current sensor decreases as the battery temperature increases. The resistance increases as the temperature decreases.
The battery current sensor is connected to the ECM. The ECM supplies 5 V from the THB terminal to the battery current sensor through resistor R.
The battery current sensor and resistor R are connected in series. This results in changes in the voltage supplied from the THB terminal when the resistance changes according to the battery temperature.
The ECM determines the battery temperature according to changes of voltage. When the battery temperature is high, the ECM determines to reduce the amount of current supplied from the generator in order to protect the battery.
A110648E01
DTC No.
DTC Detection Condition
Trouble Area
P0516
Battery current sensor output value is 0.2 V or less for 0.5 seconds or more with the ignition switch on (IG)
(1 trip detection logic)
  1. Battery current sensor
  2. Short in battery current sensor circuit
  3. ECM
P0517
Battery current sensor output value is 4.8 V or more for 0.5 seconds or more with the ignition switch on (IG)
(1 trip detection logic)
  1. Battery current sensor
  2. Open in battery current sensor circuit
  3. ECM

WIRING DIAGRAM

C128778E01

INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
If DTCs relating to different systems are output, and they share terminal E2 as their ground, check this ground circuit first.


1. INSPECT BATTERY CURRENT SENSOR

  1. C129062E03
    Disconnect the battery current sensor connector.

  1. Measure the resistance of the battery current sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B31-1 (THB) - B31-4 (E2)
    20 to 30°C (68 to 86°F)
    1.5 to 2.5 kΩ

  1. Reconnect the battery current sensor connector.



NG
REPLACE BATTERY CURRENT
OK


2. CHECK HARNESS AND CONNECTOR (BATTERY CURRENT SENSOR - ECM)

  1. A131549E03
    Disconnect the battery current sensor connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B31-1 (THB) - B32-115 (THB)
    Below 1 Ω
    B31-4 (E2) - B32-93 (EIB)
    Below 1 Ω
    B31-1 (THB) or B32-115 (THB) - Body ground
    10 kΩ or higher
    B31-4 (E2) or B32-93 (EIB) - Body ground
    10 kΩ or higher

  1. Reconnect the battery current sensor connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM


← P0504 Brake Switch "A" / "B" Correlation (from Aug 2007)P0516 Battery Temperature Sensor Circuit Low (+ P0517) (from Aug 2007) →