2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

B129996
  1. Remove the 2 screws.

  1. Detach the 2 claws and remove the instrument panel under cover.


2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)

B127987
  1. Remove the 4 bolts and driver side knee airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

B132919
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE INSTRUMENT PANEL SAFETY PAD COVER
  1. Remove the instrument panel (Click here).


5. DISCONNECT CLUTCH START SWITCH CONNECTOR (w/ Entry and Start System)
  1. Disconnect the clutch start switch connector.

  1. Remove the nut and clutch start switch from the clutch pedal support.


6. DISCONNECT CLUTCH START CANCEL SWITCH CONNECTOR (w/ Cruise Control System)
  1. Disconnect the switch connector.
    For 1AZ-FE, 2AZ-FE, refer to the following procedures (Click here).
    For 2AD-FTV, 2AD-FHV, refer to the following procedures (Click here).


7. REMOVE PUSH ROD CLEVIS PIN

C125480
  1. Remove the clip and pin.


8. REMOVE CLUTCH PEDAL ASSEMBLY

C125481
  1. Remove the bolt, 2 nuts and clutch pedal.

← REMOVAL (Nov 2005 – Dec 2006)DISASSEMBLY (from Nov 2005) →