2005-2008 RAV4 · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


1. INSTALL OUTER MIRROR COVER LH

B130149
  1. Attach the 8 claws and install the mirror cover.

  1. After installing the outer mirror cover, check that there is no gap between the cover and mirror body.

    HINT:
    If there is a gap between the cover and body, noise will occur during driving.

  1. B130150
    w/ Mirror Heater:
    Connect the 2 connectors. Attach the 4 claws to install the mirror.

  1. B130151
    w/o Mirror Heater:
    Attach the 4 claws to install the mirror.


2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

B129405E03
  1. Pass the connector labeled A and wire harness of the mirror through the wire harness hole.

  1. Temporarily install the mirror by inserting the bosses on the mirror into the holes on the vehicle.

  1. Tighten the 3 screws in the sequence shown in the illustration and install the mirror.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the connector labeled A.


3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Attach the 4 claws to install the speaker door grille.

  1. Attach the 7 claws to install the weatherstrip inner.

  1. B133485
    Attach the 2 claws to install the inside handle.

  1. B133484
    Attach the 10 clips to install the trim board.

  1. Install the 3 screws.

  1. B129164
    Attach the 3 claws to install the door inside handle bezel plug.

  1. B133479
    Attach the 12 claws to install the door assist grip.


4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

B129158
  1. Attach the clip and 3 claws to install the garnish.

← INSPECTION (from Aug 2008)INSTALLATION (from Aug 2008) →