INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT CLUTCH DISC ASSEMBLY |
Using a vernier caliper, measure the rivet head depth.

- Maximum rivet depth:
- 0.3 mm (0.012 in.)
Install the clutch disc to the transaxle.
- NOTICE:
- Take care not to insert the clutch disc in the wrong direction.
Using a dial indicator, measure the clutch disc assembly runout.

- Minimum runout:
- 0.8 mm (0.032 in.)
| INSPECT CLUTCH COVER ASSEMBLY |
Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

- Maximum:
- A (Depth):
- 0.5 mm (0.020 in.)
- B (Width):
- 6.0 mm (0.236 in.)
| INSPECT FLYWHEEL SUB-ASSEMBLY |
Using a dial indicator, measure the flywheel runout.

- Maximum runout:
- 0.1 mm (0.004 in.)
| INSPECT CLUTCH RELEASE BEARING ASSEMBLY |
Turn the release bearing by hand while applying force in the axial direction.

- HINT:
- The bearing is permanently lubricated and requires no cleaning or lubrication.
- Replace the release bearing assembly as necessary.
