2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL CLUTCH DISC ASSEMBLY

  1. C116730E01
    Insert SST into the clutch disc, and then insert them into the flywheel.
    SST
    09301-00310  

    NOTICE:
    Do not insert the clutch disc in the wrong direction.


2. INSTALL CLUTCH COVER ASSEMBLY

  1. C116732E02
    Align the matchmarks on the clutch cover with the one on the flywheel.

  1. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    NOTICE:
    1. Following the order in the illustration, make sure to uniformly tighten the bolts 180°.
    2. After checking that the disc is in the center, gently move SST up and down, and right and left to tighten the bolts.


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

  1. C116193
    C116192E01
    Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

    Maximum non-alignment:
    1.3 mm (0.050 in.)

    If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.
    SST
    09333-00013  


4. INSTALL RELEASE FORK SUPPORT

  1. C113601
    Install the release fork support to the transaxle.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }


5. INSTALL CLUTCH RELEASE FORK BOOT

  1. C113599
    Install the clutch release fork boot onto the transaxle case.


6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

  1. C133433
    Apply release hub grease to the contact surfaces of the release fork and release bearing, fork and push rod, and fork and fork support.

    Release hub grease:
    Part No. 08887-01806, RELEASE HUB GREASE or equivalent

  1. Install the fork to the release bearing.


7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

  1. C133434
    Apply clutch spline grease to the input shaft spline.

    Clutch spline grease:
    Part No. 08887-01706, CLUTCH SPLINE GREASE or equivalent

  1. C113576
    Install the bearing with release fork to the transaxle.

    NOTICE:
    After the installation, move the fork forward and backward to check that the release bearing slides smoothly.


8. INSTALL MANUAL TRANSAXLE ASSEMBLY
  1. Install the manual transaxle (Click here).

← INSPECTION (from Nov 2005)INSTALLATION (Jan 2007 – Jul 2007) →