REMOVAL
Removal / installation · Vehicles built Nov 2005 – Jul 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE BACK DOOR CENTER GARNISH
|
 |
- Using a screwdriver, detach the 4 claws and 4 clips and remove the garnish.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE BACK DOOR SIDE GARNISH LH
|
 |
- Using a screwdriver, detach the 2 claws and 2 clips and remove the garnish.
| 4.
REMOVE BACK DOOR SIDE GARNISH RH
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 5.
REMOVE BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY
|
 |
- Using a screwdriver, pry out the light as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
- Detach the 4 claws and remove the light shade.
- Remove the light bulb from the light.
| 6.
REMOVE BACK DOOR TRIM BOARD
|
 |
- Using a screwdriver, detach the 13 clips and remove the trim board.
- HINT:
- Tape the screwdriver tip before use.
- If the screwdriver cannot reach the clips, pull on the lower trim to remove it.
Remove the 5 screws and the back door trim pocket.
| 7.
REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH |
 |
- Remove the screw and 8 clips.
Remove the back door outside garnish.
| 8.
REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH (w/ License Plate Light) |
 |
Remove the screw and 7 clips.
Remove the back door outside garnish and disconnect the connector.
for 1 piece type:
Remove the 1 piece type license plate light (Click here).
for 2 piece type:
Remove the 2 piece type license plate lights (Click here).
| 9.
REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH (w/ Rear Fog Light) |
 |
Remove the screw and 8 clips.
Remove the back door outside garnish and disconnect the connector.
Remove the rear fog light (Click here).
| 10.
REMOVE UPPER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY LH |
 |
- Remove the screw and 6 clips.
Remove the back door outside garnish.
| 11.
REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY RH |
 |
- Remove the 5 clips and detach the claw.
Remove the back door outside garnish.
| 12.
REMOVE UPPER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY RH |
 |
- Remove the 6 clips and back door outside garnish.
| 13.
REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/o Tire Carrier) |
 |
- Remove the 3 nuts 6 clips.
Disconnect the connector and remove the back door outside garnish.
Remove the 2 license plate lights (Click here).
| 14.
REMOVE LOWER BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/o Tire Carrier) |
 |
- Remove 15 clips and detach the claws.
Remove the back door outside garnish.
| 15.
REMOVE BACK DOOR OUTSIDE GARNISH CLIP (w/o Tire Carrier) |
 |
- Remove the 2 screws and 2 clips.