2005-2008 RAV4 · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. REMOVE STARTER MAGNETIC SWITCH ASSEMBLY

  1. A165164
    Remove the nut, and disconnect the lead wire from the starter magnetic switch assembly.

  1. A165165
    Remove the 2 nuts and starter magnetic switch assembly.


2. REMOVE STARTER DRIVE HOUSING ASSEMBLY

  1. A165166
    Using a T30 "TORX" driver, remove the 2 bolts.

  1. Pull out the yoke and the starter commutator end frame assembly together with the armature.

  1. Remove the starter pinion drive lever.


3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A165167
    Remove the 2 screws and end frame.

    NOTICE:
    While holding down the lead wire, remove the starter commutator end frame.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A030137
    Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

  1. Disconnect the 4 brushes, and remove the brush holder.

  1. A165174
    Remove the starter armature from the yoke.


5. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the starter yoke from the starter center bearing clutch sub-assembly.


6. REMOVE STARTER ARMATURE PLATE
  1. Remove the starter armature plate from the starter center bearing clutch.


7. REMOVE PLANETARY GEAR

  1. A087891
    Remove the 3 planetary gears.

← DISASSEMBLY (Nov 2005 – Dec 2006)INSPECTION (Nov 2005 – Dec 2006) →