2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. INSTALL PLANETARY GEAR
  1. Apply high-temperature grease to the planetary gears of the planetary shaft.

  1. A087891
    Install the 3 planetary gears.


2. INSTALL STARTER ARMATURE PLATE

  1. A086452E02
    Insert the plate to the starter center bearing clutch.

  1. Check that the tab of the starter armature plate fits over the projection of the starter center bearing clutch sub-assembly.


3. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter center bearing clutch sub-assembly.


4. INSTALL STARTER YOKE ASSEMBLY

  1. A165179
    Align the tab of the starter center bearing clutch with the notch of the starter yoke, and install the starter yoke.


5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
  1. Install the starter brush holder assembly.

  1. A030137
    Using a screwdriver, hold the brush spring back and connect the brush into the brush holder.

  1. Connect the 4 brushes.

  1. Align the starter commutator end frame rubber with the groove of the starter yoke assembly.

  1. A165167
    Install the starter commutator end frame with the 2 screws.

    Torque:
    3.8 N*m{ 39 kgf*cm , 33 in.*lbf }


6. INSTALL STARTER DRIVE HOUSING ASSEMBLY
  1. Apply high-temperature grease to the starter pinion drive lever.

  1. Install the starter pinion drive lever to the starter center bearing clutch.

  1. Align the claw of the starter center bearing clutch with the groove inside the starter drive housing, and install the starter center bearing clutch to the starter drive housing.

  1. A165166
    Using a T30 "TORX" driver, install the starter drive housing with the 2 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


7. INSTALL STARTER MAGNETIC SWITCH ASSEMBLY

  1. A165165
    Install the starter magnetic switch with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. A165164
    Connect the lead wire to the terminal with the nut.

    Torque:
    6.5 N*m{ 66 kgf*cm , 57 in.*lbf }

← REASSEMBLY (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →