2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Aug 2007 – Jul 2008 from Aug 2008


NOTICE:
A199136
Do not disconnect the hose indicated in the illustration.


1. REMOVE FUEL TANK ASSEMBLY
  1. Remove the fuel tank assembly (Click here).


2. DISCONNECT FUEL EMISSION HOSE

  1. A202413E01
    Disconnect the purge line hose, air inlet line hose and fuel emission hose from the fuel suction plate.

  1. Pinch the retainer as shown in the illustration, and then disconnect the fuel emission hose from the fuel suction plate.

    NOTICE:
    1. Clean off any dirt and foreign matter from the clip before disconnecting the hoses.
    2. Do not use any tools in this procedure.
    3. Do not forcefully bend or twist the nylon tube.
    4. Put the hose in a plastic bag to prevent damage and contamination.
    5. If the connector is stuck, pinch the retainer and push and pull the hose to disconnect it.


3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124669
    Remove the joint clip and fuel tank main tube.

    NOTICE:
    1. Before removing the tube joint clip, check for foreign matter around the clip. Clean if necessary.
    2. Keep the O-ring free of foreign matter, as it becomes contaminated easily.
    3. Do not use any tools in this procedure.
    4. Do not forcefully bend or twist the tube.
    5. Put the tube in a plastic bag to prevent damage and contamination.
    6. If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
    7. Be careful not to damage the clip. If the clip is damaged, replace it.


4. REMOVE FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Remove the 8 bolts and set plate.


5. REMOVE FUEL SUCTION WITH PUMP ASSEMBLY

  1. A124676
    Disconnect the fuel hose and remove the fuel suction with pump from the fuel tank.

    NOTICE:
    Do not damage the fuel suction with pump.

  1. A126699E02
    Remove the gasket from the fuel suction with pump.


6. REMOVE NO. 1 FUEL SUB-TANK

  1. A126123
    Disconnect the wire harness.

  1. A201342E01
    Using needle nose pliers, remove the E-ring.

    HINT:
    Slightly lower the fuel suction plate to remove the E-ring.

  1. A126684
    Remove the 2 springs from the 2 shafts.

  1. A126125
    Detach the 2 claws and remove the No. 1 fuel sub-tank.

  1. A126798E01
    Detach the claw of the jet pump nozzle.

  1. Using a screwdriver, remove the jet pump.

    HINT:
    Tape the screwdriver tip before use.

  1. A195888E01
    Remove the O-ring from the jet pump.


7. REMOVE NO. 1 FUEL SUCTION SUPPORT

  1. A126126
    Using needle-nose pliers, detach the 2 claws and remove the No. 1 fuel suction support.


8. REMOVE FUEL PUMP ASSEMBLY

  1. A197085
    Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.

    HINT:
    When detaching the claws, do not disconnect the fuel main tube.

  1. A197086
    Disconnect the fuel pump connector.

  1. A197087E01
    Remove the O-ring from the fuel filter.

  1. Remove the fuel pump spacer from the fuel pump assembly.

← REMOVAL (Aug 2007 – Jul 2008)DISASSEMBLY (Aug 2007 – Jul 2008) →