2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL EVAPORATOR TEMPERATURE SENSOR

NOTICE:
If reusing the evaporator, do not insert the sensor to a location where the sensor was previously inserted. Insert the sensor within range C shown in the illustration.

  1. E124283E01
    Install the evaporator temperature sensor as shown in the illustration.


2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

  1. E124281
    Install the cooler thermistor and cooler evaporator on the case.

  1. Attach the temperature sensor clamp.

  1. E124280
    Attach the 2 claws to install the cover.

  1. Install the 4 screws.


3. INSTALL COOLER EXPANSION VALVE

  1. E124278
    Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the cooler evaporator.

  1. Install the cooler expansion valve.

  1. Using a 4 mm hexagon wrench, install the A/C tube with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 35 kgf*cm , 30 in.*lbf }


4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

  1. E124279
    Install the heater radiator with the clamp and screw.


5. INSTALL AIRMIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)

  1. H102209
    Attach the 3 claws to install the cable.


6. INSTALL MODE CONTROL CABLE ASSEMBLY (for Manual Air Conditioning System)

  1. H102208
    Attach the 3 claws to install the cable.

  1. E127171
    Attach the evaporator case to the blower case.

  1. Install the blower case with the 3 screws.


7. INSTALL AIR MIX CONTROL SERVO MOTOR

  1. E124276
    Install the air mix control servo motor with the 3 screws and connect the connector.


8. INSTALL AIR OUTLET CONTROL SERVO MOTOR

  1. E124277
    Install the air outlet control servo motor with the 3 screws and connect the connector.

  1. E127171
    Attach the evaporator case to the blower case.

  1. Install the 3 screws.


9. INSTALL AIR DUCT

  1. E126460
    Attach the 2 claws and install the air duct.


10. INSTALL NO. 3 HEATER TO REGISTER DUCT

  1. E127161
    Attach the 6 claws and install the heater to register duct.

← DISASSEMBLY (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →