2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    07110-58060   (07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. REMOVE FRONT BUMPER COVER
  1. Remove front bumper cover (Click here).


4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

  1. H102042
    Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler condenser.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


5. DISCONNECT COOLER REFRIGERANT LIQUID PIPE

  1. H102043
    Remove the bolt and disconnect the cooler refrigerant liquid pipe from the cooler condenser.

  1. Remove the O-ring from the cooler refrigerant liquid pipe.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


6. REMOVE RADIATOR SUPPORT UPPER BRACKET

  1. E126555
    Remove the 2 bolts and 2 brackets.


7. REMOVE NO. 2 FAN SHROUD (for 1AZ-FE, 2AZ-FE)

E126556
  1. Remove the 2 bolts and fan shroud.


8. REMOVE NO. 1 RADIATOR SUPPORT (for 2AD-FHV, 2AD-FTV)

E126557
  1. Remove the 4 bolts and 2 radiator supports.


9. REMOVE COOLER CONDENSER ASSEMBLY

  1. B135838
    Remove the cooler condenser.


10. REMOVE COOLER DRYER

  1. I030086E01
    Using a 14 mm socket hexagon wrench, remove the cap from the modulator.

  1. I032475E01
    Remove the O-ring from the cap.

  1. E050386E01
    Using pliers, remove the cooler dryer.

← ON-VEHICLE INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →