P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor)
Diagnostic trouble codes · Vehicles built from Aug 2007
Versions by build date: Jan 2007 – Jul 2007 from Aug 2007
DESCRIPTION
The camshaft position sensor (G signal) consists of a magnet, iron core and pickup coil.The G signal plate (timing sprocket) has one tooth on its outer circumference and is installed on the camshaft timing chain gear. When the timing gear rotates, the protrusion on the signal plate and the air gap on the pickup coil change, causing fluctuations in the magnetic field that generate a voltage in the pickup coil.
The NE signal plate has 34 teeth and is mounted on the crank angle sensor plate. The NE signal sensor generates 34 signals for every engine revolution. The ECM detects the standard crankshaft angle based on the G signal and the actual crankshaft angle and the engine speed by the NE signal.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0340 |
When either condition below is met:
|
|
WIRING DIAGRAM
Refer to DTC P0335 (Click here).INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
| 1. INSPECT CAMSHAFT POSITION SENSOR |
Disconnect the camshaft position sensor connector.

Measure the resistance of the camshaft position sensor.
- Standard resistance:
Tester Connection
Specified Condition
B35-1 - B35-2
835 to 1,400 Ω at cold
B35-1 - B35-2
1,060 to 1,645 Ω at hot
- HINT:
- In the table above, the terms "Cold" and "Hot" refer to the temperature of the coils in the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
Reconnect the camshaft position sensor connector.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
Disconnect the camshaft position sensor connector.

Disconnect the ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
B35-1 - B32-80 (G+)
Below 1 Ω
B35-2 - B32-79 (G-)
Below 1 Ω
B35-1 or B32-80 (G+) - Body ground
10 kΩ or higher
B35-2 or B32-79 (G-) - Body ground
10 kΩ or higher
Reconnect the camshaft position sensor connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 3. CHECK CAMSHAFT POSITION SENSOR (SENSOR INSTALLATION) |
Check the sensor installation.

- OK:
- Sensor is installed correctly.
|
|
||||
| OK | |
| 4. CHECK CAMSHAFT TIMING SPROCKET |
Check the condition of the timing sprocket.
- OK:
- Timing sprocket does not have any cracks or deformation.
|
|
||||
| OK | ||
| ||
