2005-2008 RAV4 · Service Manual ENGINE

P0627 Fuel Pump Control Circuit / Open

Diagnostic trouble codes · Vehicles built from Aug 2007

Versions by build date: Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
P0627
Open or short in suction control valve circuit for more than 0.5 seconds
(1 trip detection logic)
  1. Open or short in suction control valve circuit
  2. Suction control valve
  3. ECM

HINT:
  1. For more information on the supply pump (suction control valve) and the common rail system, refer to the system description (Click here).
  2. When DTC P0627 is set, check the internal fuel pressure of the common rail by entering the following menus on the intelligent tester: Powertrain / Engine and ECT / Data List / Fuel Press.
Reference: 
Engine Speed
Fuel Pressure
Idling
Approximately 38 to 43 MPa
2,500 rpm (No engine load)
Approximately 69 to 88 MPa


WIRING DIAGRAM

Refer to DTC P0088 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
  2. After replacing a supply pump, the ECM needs initialization (Click here).


1. INSPECT SUPPLY PUMP ASSEMBLY

  1. A113717E02
    Disconnect the suction control valve connector.

  1. Measure the resistance of the suction control valve.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B46-1 - B46-2
    20°C (68°F)
    1.9 to 2.3 Ω

  1. Reconnect the suction control valve connector.



NG
REPLACE SUPPLY PUMP ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (SCV - ECM)

  1. A128632E05
    Disconnect the suction control valve connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B46-1 - B32-42 (PCV+)
    Below 1 Ω
    B46-2 - B32-41 (PCV-)
    Below 1 Ω
    B46-1 or B32-42 (PCV+) - Body ground
    10 kΩ or higher
    B46-2 or B32-41 (PCV-) - Body ground
    10 kΩ or higher

  1. Reconnect the suction control valve connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear DTCs (Click here).

  1. Turn the ignition switch on (IG) and leave it for approximately 1 minute.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result:
    Display (DTC Output)
    Proceed to
    P0627
    A
    No output
    B



B
CHECK FOR INTERMITTENT PROBLEMS
A

REPLACE ECM


← P0627 Fuel Pump Control Circuit / Open (Jan 2007 – Jul 2007)P1238 Injector Malfunction (Jan 2007 – Jul 2007) →