2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

Tire Pressure Warning Light Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

If the tire pressure warning ECU and receiver detects trouble, the tire pressure warning light turns on and tire pressure monitor is canceled at the same time. At this time, the ECU records a DTC in memory.
Connect terminals TC and CG of the DLC3 to make the tire pressure warning light blink and output the DTC.

WIRING DIAGRAM

F101028E02

INSPECTION PROCEDURE


1. INSPECT FUSE (GAUGE2)
  1. Remove the GAUGE2 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

Standard resistance:
Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK TIRE PRESSURE WARNING LIGHT CIRCUIT
F101029E01
  1. Disconnect the E64 ECU connector.

  1. Using a service wire, connect E64-5 (IND) on the wire harness side and body ground.

  1. Turn the ignition switch on (IG).

  1. Check that the tire pressure warning light turns on.

    OK:
    Tire pressure warning light turns on.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


3. CHECK WIRE HARNESS (ECU - METER)
F101031E05
  1. Disconnect the E64 ECU connector.

  1. Disconnect the E22 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E64-5 (IND) - E22-5 (TIRE)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← C2195/95 Multi-receiver Antenna Circuit (Test Mode DTC) (from Nov 2005)ECU Power Source Circuit (from Nov 2005) →