ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2007
| DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| INSPECT INSTRUMENT PANEL JUNCTION BLOCK |
- NOTICE:
- The circuit opening (C/OPN) relay is built into the instrument panel junction block.
Measure the resistance between the terminals.

- Standard resistance:
Tester Connection
Specified Condition
1B-11 - 1A-8
10 kΩ or higher
1B-11 - 1A-8
Below 1 Ω
(when battery voltage is applied to terminals IF-4 and IE-5)
| CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
