2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2007


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

REMOVE IG2 RELAY
  1. Remove the engine room No. 1 relay block cover.

  1. Remove the IG2 relay from the engine room No. 1 relay block.


INSPECT IG2 RELAY

  1. B060778E14
    Measure the resistance of the IG2 relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.


INSTALL IG2 RELAY

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← ON-VEHICLE INSPECTION (from Aug 2007)ON-VEHICLE INSPECTION (from Aug 2007) →