2005-2008 RAV4 · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL PARKING BRAKE SWITCH ASSEMBLY
  1. Install the parking brake switch with the screw.

    Torque:
    0.88 N*m{ 9.0 kgf*cm , 7.8 in.*lbf }


2. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
  1. Connect the cable to the lever.


3. INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY

  1. C129092
    Install the parking brake lever (with the No. 1 parking brake cable) with the 2 bolts.

    Torque:
    14.5 N*m{ 148 kgf*cm , 11 ft.*lbf }

  1. C129065
    Connect the No. 1 parking brake cable to the parking brake equalizer.

  1. C129091
    Temporarily install the wire adjusting nut and lock nut.

  1. Connect the parking brake switch connector.


4. CHECK PARKING BRAKE LEVER TRAVEL
  1. Pull the lever upward with a force of approximately 200 N (20 kgf, 44 lbf) and count the number of clicks.

    OK:
    7 to 9 clicks (without rear brake dragging)


5. ADJUST PARKING BRAKE LEVER TRAVEL

  1. C127319E01
    Turn the No. 1 wire adjusting nut until the lever travel is correct.

    OK:
    7 to 9 clicks (without rear brake dragging)
    <Lever pulling force: approximately 200 N (20 kgf, 44 lbf)>

  1. Tighten the lock nut.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

    OK:
    7 to 9 clicks (without rear brake dragging)
    <Lever pulling force: approximately 200 N (20 kgf, 44 lbf)>

  1. When operating the parking brake lever, check that the brake warning light illuminates at the first click.

    Standard condition:
    Brake warning light always illuminates at the first click.


6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
  1. Install the rear console box (Click here).

    HINT:
    Refer to the procedures from the installation of the rear console box sub-assembly up until the installation of the No. 1 console upper panel garnish.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← REMOVAL (from Jan 2007)INSTALLATION (Jan 2007 – Jul 2007) →