2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL CLUTCH DISC ASSEMBLY

C127508E01
  1. Insert SST in the disc, then insert them in the flywheel.

    SST
    09301-00210  

    NOTICE:
    Take care not to insert the clutch disc in the wrong direction.


2. INSTALL CLUTCH COVER ASSEMBLY

C127509E01
  1. Align the matchmarks on the cover and flywheel.

  1. Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin on the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Following the order in the illustration, tighten the bolts one at a time, evenly.
    2. Move SST up and down, and right and left lightly after checking that the disc is in the center to tighten the bolts.

    SST
    09301-00210  


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

  1. C127510
    C127511E01
    Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

    Maximum misalignment:
    0.5 mm (0.020 in.)

    If the alignment is greater than the maximum, use SST to adjust the diaphragm spring tip alignment.
    SST
    09333-00013  


4. INSTALL RELEASE FORK SUPPORT
  1. Install the release fork support on the transaxle.

    Torque:
    47 N*m{ 479 kgf*cm , 34 ft.*lbf }


5. INSTALL CLUTCH RELEASE FORK BOOT

6. INSTALL RELEASE BEARING HUB CLIP

7. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

  1. C128464E01
    Apply release hub grease to the contact surfaces of the release fork and release bearing, fork and push rod, and fork and fork support.

    Release hub grease:
    Part No. 08887-01806, RELEASE HUB GREASE or equivalent

  1. Install the fork to the release bearing.


8. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

  1. C133434
    Apply clutch spline grease to the input shaft spline.

    Clutch spline grease:
    Part No. 08887-01706, CLUTCH SPLINE GREASE or equivalent

  1. C127501
    Install the bearing with release fork to the transaxle.

    NOTICE:
    After the installation, move the fork forward and backward to check that the release bearing slides smoothly.


9. INSTALL MANUAL TRANSAXLE ASSEMBLY
  1. Install the manual transaxle.
    For E352F, E359F, refer to the following procedures (Click here).
    For E352, refer to the following procedures (Click here).

← INSTALLATION (Jan 2007 – Jul 2007)COMPONENTS (from Nov 2005) →