2005-2008 RAV4 · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007


CHECK BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust or scoring.
    If necessary, replace the cylinder and piston.


CHECK PAD LINING THICKNESS

  1. C127292
    Using a ruler, measure the pad lining thickness.

    Standard thickness:
    10.5 mm (0.413 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)

    If the pad lining thickness is less than the minimum, replace the pad.


CHECK REAR DISC BRAKE PAD SUPPORT PLATE
  1. Check the 2 plates as follows. If necessary, replace the plates.

    1. Use brake cleaner to clean the pad of the pad support plate and cylinder mounting contact surface. Inspect for deformation, cracks, rust and foreign matter that is difficult to remove.

    2. Use brake cleaner to clean the pad support plate contact surface of the cylinder mounting. After installing the pad support plate to the cylinder mounting, inspect for looseness and deformation.

    3. After installing the pad, inspect if the pad falls off easily (due to the spring force of the pad support plate).


CHECK DISC THICKNESS

  1. C127293
    Using a micrometer, measure the disc thickness.

    Standard thickness:
    12.0 mm (0.472 in.)

    Minimum thickness:
    10.5 mm (0.413 in.)

    If the disc thickness is less than the minimum, replace the disc.


CHECK DISC RUNOUT
  1. Check the bearing backlash and axle hub deviation (Click here).

  1. Tighten the disc with the 5 hub nuts.

    Torque:
    103 N*m{ 1050 kgf*cm , 76 ft.*lbf }

  1. C193403
    Using a dial indicator, measure the disc runout 10 mm (0.39 in.) from the outer edge of the disc.

    Maximum disc runout:
    0.15 mm (0.0059 in.)

    If the runout is more than the maximum, change the installation positions of the disc and axle so that the runout is the smallest possible.
    If the runout is more than the maximum even when the installation positions are changed, grind the disc.
    If the disc thickness is less than the minimum, replace the disc.

  1. Remove the 5 hub nuts and disc.

← INSPECTION (Nov 2005 – Jul 2007)REASSEMBLY (Nov 2005 – Dec 2006) →