Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.
INSTALL REAR DISC
Align the matchmarks and install the disc.
HINT:
When replacing the disc with a new one, select the installation position where the disc has the minimum runout.
2.
INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Install the adjusting hole plug to the rear disc.
3.
CHECK DISC RUNOUT
Check the bearing backlash and axle hub deviation (Click here).
Tighten the disc with the 3 hub nuts.
Torque:
103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) from the outer edge of the disc.
Maximum disc runout:
0.15 mm (0.0059 in.)
If the runout is greater than the maximum, change the installation positions of the disc and axle so that the runout will become minimal. If the runout is greater than the maximum even when the installation positions are changed, grind the disc. If the disc thickness is less than the minimum, replace the disc.
Remove the 3 hub nuts.
4.
ADJUST PARKING BRAKE SHOE CLEARANCE
Temporarily install the hub nuts.
Remove the shoe adjusting hole plug, and then turn the adjuster to expand the shoe adjuster until the disc locks.
Turn and contact the shoe adjuster until the disc can rotate smoothly.