C1249/49 Open in Stop Light Switch Circuit
Diagnostic trouble codes · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008
DESCRIPTION
The skid control ECU detects the brake operating conditions through a signal transmitted by the stop light switch. The skid control ECU incorporates an open circuit detection circuit. This DTC is set under either of the following conditions:- An open is detected in the stop light signal input line when the stop light switch is off.
- An open is detected in the stop light circuit lead to the ground when the stop light switch is off.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1249/49 |
When IG1 terminal voltage is 9.5 to 18.5 V, open circuit of stop light switch continues for 3 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Check the Data List for proper functioning of the stop light switch.
Skid control ECU Item (Display)
Measurement Item / Range (Display)
Normal Conditions
Stop Lamp SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
- OK:
- ON (brake pedal is depressed) appears on the screen.
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (STP VOLTAGE) |
Disconnect the A27 ECU connector.

Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
A27-10 (STP) - Body ground
Brake pedal depressed
8 to 14 V
A27-10 (STP) - Body ground
Brake pedal released
Below 4.0 V
|
|
||||
| OK | ||
| ||
| 3. INSPECT FUSE (STOP) |
Remove the STOP fuse from the instrument panel junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT STOP LIGHT SWITCH ASSEMBLY |
Disconnect the stop light switch connector.

Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pin not pushed
Below 1 Ω
1 - 2
Pin pushed
10 kΩ or higher
3 - 4
Pin not pushed
10 kΩ or higher
3 - 4
Pin pushed
Below 1 Ω
|
|
||||
| OK | |
| 5. CHECK WIRE HARNESS (SKID CONTROL ECU - STOP LIGHT SWITCH) |
Disconnect the A27 ECU connector.

Disconnect the A5 switch connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
A27-10 (STP) - A5-1
Below 1 Ω
|
|
||||
| OK | |
| 6. RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
