INSPECTION
Inspection · Vehicles built from Aug 2007
| INSPECT FUEL INJECTOR ASSEMBLY |
Check the resistance.

Using an ohmmeter, measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester connection
Condition
Specified Condition
1 - 2
20°C (68°F)
11.6 to 12.4 Ω
Check the operation.
- CAUTION:
- Perform the inspection in a well-ventilated area.
- Do not perform the inspection near a naked flame.
Connect SST (fuel tube connector) to SST (hose), then connect them to the fuel pipe (vehicle side).

- SST
- 09268-31012
(09268-41500, 90467-13001, 95336-08070)
Install the O-ring onto the fuel injector assembly.

- SST
- 09268-31012
(90467-13001, 95336-08070)
09268-41140
09268-41400
Connect SST (adapter and hose) to the injector assembly, and hold the injector assembly and union with SST (clamp).
Set the injector assembly in a graduated cylinder.
- CAUTION:
- Install a suitable vinyl tube onto the injector assembly to prevent gasoline from spraying.
Operate the fuel pump (Click here).
Connect SST (wire) to the injector assembly and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

- SST
- 09842-30080
- Injection volume:
Tester Connection
Condition
Specified Condition
Positive terminal - Ground terminal
Per 15 seconds
84 to 100 cm3 (5.1 to 6.0 cu in.)
- Difference between each injector:
- 16 cm3 (0.96 cu in.) or less
- NOTICE:
- Always do the switching on the battery side.
Check the leakage.

Disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the injector.
- Fuel drop:
- 1 drop or less every 16 minutes
