2005-2008 RAV4 · Service Manual BODY

ADJUSTMENT

Removal / installation · Vehicles built from Nov 2005

B057104E13

HINT:
  1. Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. ADJUST BACK DOOR

  1. B129930
    Loosen the body's hinge bolts and adjust the door's position.

  1. Tighten the body's hinge bolts after the adjustment.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }

  1. B129931
    Loosen the door's hinge bolts and adjust the door's position.

  1. Tighten the door's hinge bolts after the adjustment.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }

  1. B133658
    Using a T40 "torx" socket, adjust the striker position by slightly loosening the striker mounting screws and then hitting the striker with a plastic-faced hammer.

  1. Using a T40 "torx" socket, tighten the striker mounting screws after the adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }

  1. B133659
    Using a T30 "torx" socket, adjust the side male stopper position by slightly loosening the striker mounting screws and then hitting the striker with a plastic-faced hammer.

  1. Using a T30 "torx" socket, tighten the side male stopper mounting screws after the adjustment.

  1. B129932
    Loosen the side female stopper bolts and adjust the door's position

  1. Tighten the side female stopper bolts after the adjustment.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →