2005-2008 RAV4 · Service Manual BRAKE

C1201/51 Engine Control System Malfunction

Diagnostic trouble codes · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008

DESCRIPTION

If a malfunction in the engine control system is detected, the operations of VSC and TRC are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is canceled and the DTC is not stored.
DTC No.
DTC Detection Condition
Trouble Area
C1201/51
Engine control system malfunction signal continues for 5 seconds.
Engine control system

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)
  1. Using the Data list of the intelligent tester, check for any momentary interruption in the wire harness corresponding to the DTC (Click here).

    Skid control ECU 
    Item
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    EFI Communication Open
    EFI communication open detection / ERROR or NORMAL
    ERROR: Momentary interruption
    NORMAL: Normal
    -

    OK:
    There are no momentary interruptions.

    HINT:
    Perform the above inspection before removing the sensor and connector.



NG
Go to step 3
OK


2. CHECK DTC FOR ENGINE CONTROL SYSTEM
  1. Clear the DTC (engine control system).

  1. Check the DTC (engine control system).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
REPLACE ECM
A

REPAIR ENGINE CONTROL SYSTEM

3. REPAIR OR REPLACE HARNESS AND CONNECTOR (ECM - SKID CONTROL ECU)

NEXT


4. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Perform a road test.

  1. Check if the same DTC is recorded (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC C1201/51 is output
    B



B
Go to step 2
A

END


← C1201/51 Engine Control System Malfunction (Jan 2007 – Jul 2007)C1203 ECM Communication Circuit Malfunction (from Aug 2008) →