If a malfunction in the engine control system is detected, the operations of VSC and TRC are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is canceled and the DTC is not stored.
DTC No.
DTC Detection Condition
Trouble Area
C1201/51
Engine control system malfunction signal continues for 5 seconds.
Engine control system
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)
Using the Data list of the intelligent tester, check for any momentary interruption in the wire harness corresponding to the DTC (Click here).
Skid control ECU
Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
EFI Communication Open
EFI communication open detection / ERROR or NORMAL
ERROR: Momentary interruption NORMAL: Normal
-
OK:
There are no momentary interruptions.
HINT:
Perform the above inspection before removing the sensor and connector.