2005-2008 RAV4 · Service Manual BRAKE

VSC Warning Light does not Come ON

Circuit diagnosis · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008

DESCRIPTION

Refer to the description of "VSC Warning Light Remains ON" (Click here).

WIRING DIAGRAM

Refer to the VSC warning light circuit (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the VSC warning light operates.

    Skid control ECU 
    Item (Display)
    Test Details
    Diagnostic Note
    VSC Warning Lamp
    Turn VSC warning light ON / OFF
    Observe combination meter

    OK:
    The VSC warning light turns on or off.



OK
REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG


3. CHECK COMBINATION METER
  1. Check the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← VSC Warning Light does not Come ON (Nov 2005 – Dec 2006)VSC Warning Light does not Come ON (Aug 2007 – Jul 2008) →