VSC Warning Light does not Come ON
Circuit diagnosis · Vehicles built Aug 2007 – Jul 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008
DESCRIPTION
Refer to the description of "VSC Warning Light Remains ON" (Click here).WIRING DIAGRAM
Refer to the VSC warning light circuit (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).
| 1. INSPECT CAN COMMUNICATION SYSTEM |
 |
Check if the CAN communication system DTC is output (Click here).
Result
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B |
 |
|
| REPAIR CAN COMMUNICATION SYSTEM |
|
|
| A |
|
 |
|
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC WARNING LIGHT) |
 |
Select the Active Test, generate a control command, and then check that the VSC warning light operates.
Skid control ECU
Item (Display)
|
Test Details
|
Diagnostic Note
|
VSC Warning Lamp
|
Turn VSC warning light ON / OFF
|
Observe combination meter
|
- OK:
- The VSC warning light turns on or off.
|
OK |
 |
|
| REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY |
|
|
| NG |
|
 |
|
| 3. CHECK COMBINATION METER |
 |
Check the combination meter (Click here).
|
NG |
 |
|
| REPLACE COMBINATION METER |
|
|
| OK |
|
 |
|
| REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY |
|