Troubleshooting · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006from Jan 2007
HINT:
Use these procedures to troubleshoot the engine immobiliser system.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
3.CRANK ENGINE FOR MORE THAN 10 SECONDS
NEXT
4.CHECK FOR DTC*
Check for DTCs and make a note of any codes that are output (Click here).
Clear the DTC.
Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same SFI system DTC, ECD system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.