2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

Main Body ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
MAIN BODY ECU COMMUNICATION STOP MODE
  1. Integrated J/B is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "MAIN BODY ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside main body ECU
  2. Main body ECU branch wire and connector
  3. Main body ECU

WIRING DIAGRAM

C129198E03

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE)

  1. C129204E02
    Disconnect the E20 or E19 main body ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    w/o Entry and Start System:
    Tester Connection
    Condition
    Specified Condition
    E20-15 (CANH) - E20-16 (CANL)
    Ignition switch off
    54 to 69 Ω
    w/ Entry and Start System:
    Tester Connection
    Condition
    Specified Condition
    E19-11 (CANP) - E19-12 (CANN)
    Ignition switch off
    108 to 132Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO MAIN BODY ECU (CANH, CANL)
OK


2. CHECK WIRE HARNESS (MAIN BODY ECU - BATTERY AND BODY GROUND)
C129205E02
  1. Disconnect the E19 main body ECU connector.

  1. Disconnect the IE and IB junction block connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E19-4 (GND2) - Body ground
    Below 1 Ω
    IE-17 (GND1) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    IB-30 (BECU) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)


← ECM Communication Stop Mode (from Nov 2005)Combination Meter ECU Communication Stop Mode (from Nov 2005) →