2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
COMBINATION METER ECU COMMUNICATION STOP MODE
  1. Combination Meter is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "COMBINATION METER ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside combination meter ECU
  2. Combination meter ECU branch wire and connector
  3. Combination meter ECU

WIRING DIAGRAM

C132300E02

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ECU - BATTERY AND BODY GROUND)
C128049E04
  1. Disconnect the E22 combination meter ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E22-33 (ET) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E22-22 (B) - Body ground
    Always
    10 to 14 V
    E22-21 (IG+) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ECU


← Main Body ECU Communication Stop Mode (from Nov 2005)Center Airbag Sensor Communication Stop Mode (from Nov 2005) →