The downhill assist control indicator light comes on when the downhill assist control is ready (Click here).
HINT:
When the downhill assist control switch is pushed on, the downhill assist control function is available and the downhill assist control indicator light illuminates.
Even if the downhill assist control switch is pressed, the downhill assist control indicator light will blink and downhill assist control will not be activated under the following conditions:
Gear position is not L or R.
The system is malfunctioning.
Temperature of the hydraulic brake booster increases and downhill assist control is temporarily canceled.
The vehicle speed is 25 km/h (15 mph) or more.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
Check if the CAN communication system DTC is output (Click here).
Result
Result
Proceed to
DTC not output
A
DTC output
B
B
REPAIR CAN COMMUNICATION SYSTEM
A
2. CHECK SKID CONTROL ECU CONNECTOR
Check if the skid control ECU connector is securely connected.
OK:
The connector is securely connected.
NG
CONNECT CONNECTOR CORRECTLY
OK
3. CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND)
Disconnect the A26 ECU connector.
Measure the resistance of the wire harness side connector.