2005-2008 RAV4 · Service Manual BRAKE

Downhill Assist Control Indicator Light Remains ON

Circuit diagnosis · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

When the downhill assist control switch is pushed on, the downhill assist control function is available and the downhill assist control indicator light illuminates.

HINT:
Even if the downhill assist control switch is pressed, the downhill assist control indicator light will blink and downhill assist control will not be activated under the following conditions:
  1. Gear position is not L or R.
  2. The system is malfunctioning.
  3. The vehicle speed is 25 km/h (15 mph) or more.


WIRING DIAGRAM

C194143E03

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND)

  1. C194130E24
    Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A67-29 (HDCS) - Body ground
    Downhill assist control switch is pushed
    Below 1 Ω
    Downhill assist control switch is not pushed
    10 kΩ or higher



OK
Go to step 6
NG


4. INSPECT DOWNHILL ASSIST CONTROL SWITCH

  1. C128533E07
    Remove the downhill assist control switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch is pushed
    Below 1 Ω
    Switch is not pushed
    10 kΩ or higher



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH
OK


5. CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND)

  1. C194144E03
    Disconnect the skid control ECU connector.

  1. Disconnect the downhill assist control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A67-29 (HDCS) - E36-4
    Always
    Below 1 Ω
    A67-29 (HDCS) - Body ground
    Always
    10 kΩ or higher
    E36-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Downhill Assist Control Indicator Light Remains ON (Aug 2007 – Jul 2008)Downhill Assist Control Indicator Light does not Come ON (Nov 2005 – Dec 2006) →