2005-2008 RAV4 · Service Manual BRAKE

Downhill Assist Control Indicator Light Remains ON

Circuit diagnosis · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

The downhill assist control indicator light comes on when the downhill assist control is ready (Click here).

HINT:
When the downhill assist control switch is pushed on, the downhill assist control function is available and the downhill assist control indicator light illuminates.
Even if the downhill assist control switch is pressed, the downhill assist control indicator light will blink and downhill assist control will not be activated under the following conditions:
  1. Gear position is not L or R.
  2. The system is malfunctioning.
  3. Temperature of the hydraulic brake booster increases and downhill assist control is temporarily canceled.
  4. The vehicle speed is 25 km/h (15 mph) or more.


WIRING DIAGRAM

C126313E01
C126314E01

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. CHECK SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND)

  1. C121700E37
    Disconnect the A26 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A26-28 (HDCS) - Body ground
    Downhill assist control switch is pushed
    Below 1 Ω
    A26-28 (HDCS) - Body ground
    Downhill assist control switch is not pushed
    10 kΩ or higher



OK
Go to step 6
NG


4. INSPECT DOWNHILL ASSIST CONTROL SWITCH

  1. C128533E06
    Remove the downhill assist control switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch is pushed
    Below 1 Ω
    1 - 4
    Switch is not pushed
    10 kΩ or higher



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH
OK


5. CHECK WIRE HARNESS (CONTROL SWITCH - SKID CONTROL ECU AND BODY GROUND)

  1. C131804E02
    Disconnect the A26 ECU connector.

  1. Disconnect the E36 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A26-28 (HDCS) - E36-4
    Below 1 Ω
    E36-1 - Body ground
    Below 1 Ω
    A26-28 (HDCS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


6. CHECK COMBINATION METER
  1. Check the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← Downhill Assist Control Indicator Light Remains ON (Nov 2005 – Dec 2006)Downhill Assist Control Indicator Light Remains ON (Aug 2007 – Jul 2008) →