2005-2008 RAV4 · Service Manual BRAKE

Downhill Assist Control Indicator Light does not Come ON

Circuit diagnosis · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

Refer to the description of "Downhill Assist Control Indicator Light Remains ON" (Click here).

WIRING DIAGRAM

Refer to the downhill assist control indicator light circuit (Click here).

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

Result 
Result
Proceed to
DTC is not output
A
DTC is output
B


B
REPAIR CAN COMMUNICATION SYSTEM
A


2. READ VALUE USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH)
  1. Check the Data List for proper functioning of the downhill assist control switch.

    Skid control ECU 
    Item (Display)
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    Downhill assist control Switch
    Downhill assist control switch / ON or OFF
    ON: Downhill assist control switch is ON
    OFF: Downhill assist control switch is OFF
    -

    OK:
    ON (downhill assist control switch is ON) appears on the screen.



NG
Go to step 5
OK


3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL INDICATOR LIGHT)
  1. Select the Active Test, generate a control command, and then check that the downhill assist control indicator light operates.

    Skid control ECU 
    Item (Display)
    Test Details
    Diagnostic Note
    DAC Indicator Lamp
    Turn downhill assist control indicator light ON / OFF
    Observe combination meter

    OK:
    The downhill assist control indicator light turns ON and OFF.



OK
REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG


4. CHECK COMBINATION METER
  1. Check the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY

5. INSPECT DOWNHILL ASSIST CONTROL SWITCH
C128533E06
  1. Remove the downhill assist control switch.

  1. Measure the resistance of the switch.

Standard resistance:
Tester Connection
Switch Condition
Specified Condition
4 - 1
Switch is pushed
Below 1 Ω
4 - 1
Switch is not pushed
10 kΩ or higher



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH
OK


6. CHECK WIRE HARNESS (CONTROL SWITCH - SKID CONTROL ECU AND BODY GROUND)
C131804E02
  1. Disconnect the A26 ECU connector.

  1. Disconnect the E36 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A26-28 (HDCS) - E36-4
    Below 1 Ω
    E36-1 - Body ground
    Below 1 Ω
    A26-28 (HDCS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← Downhill Assist Control Indicator Light does not Come ON (Jan 2007 – Jul 2007)Downhill Assist Control Indicator Light does not Come ON (from Aug 2008) →