2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL FLOOR SHIFT ASSEMBLY

  1. C127814
    Connect the 2 connectors and attach the clamp.

  1. C127815
    Install the floor shift with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C118484E01
    Turn the nut of the control cable and push in the lock.

  1. C169077E01
    Install the control cable onto the shift lever retainer.

    HINT:
    1. Install the cable with the protrusion on the outer part of the cable facing upward.
    2. After installation, check that the outer part of the cable protrudes above the A-A line as shown in the illustration.

  1. C135727E01
    Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.

  1. C167915E01
    Install the transmission control cable end to the shift lever assembly.

    HINT:
    1. Check that the lock piece is pulled outward.
    2. Install the cable end all the way to the base of the pin.

  1. C167916E01
    Push the lock piece into the adjuster case.

    HINT:
    Securely push in the lock piece until the slider lock is engaged.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. INSPECT SHIFT LEVER POSITION
  1. When shifting the lever from the P position to the R position with the ignition switch in the ON position and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

  1. Start the engine and make sure that the vehicle moves forward when shifting the lever from the N position to the D position and moves rearward when shifting the lever to the R position.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.


5. ADJUST SHIFT LEVER POSITION
  1. Apply the parking brake and move the shift lever to the N position.

  1. Remove the rear console box sub-assembly (Click here).

  1. C135091
    Disconnect the end of the transmission control cable assembly from the shift lever assembly.

  1. C127813
    Turn the lock nut counterclockwise. While holding the lock nut, disconnect the transmission control cable from the shift lever retainer.

  1. C135727E01
    Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.

  1. C163770E01
    Turn the lock nut of the transmission control cable counterclockwise. While holding the lock nut, push in the lock.

  1. C169077E01
    Connect the outer part of the transmission control cable to the shift lever retainer.

    HINT:
    1. Install the cable with the protrusion on the outer parts of the cable facing upward.
    2. After installation, check that the outer part of the cable protrudes above the A-A line as shown in the illustration.

  1. C167915E01
    Install the transmission control cable end to the shift lever assembly.

    HINT:
    1. Check that the lock piece is pulled outward.
    2. Install the cable end all the way to the base of the pin.

  1. C167916E01
    Push the lock piece into the adjuster case.

    HINT:
    Securely push in the lock piece until the slider lock is engaged.

  1. Install the rear console box sub-assembly (Click here).


6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
  1. Install the rear console box sub-assembly (Click here).


7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

  1. C169081
    Install the shift lever knob sub-assembly.

← REASSEMBLY (from Aug 2007)COMPONENTS (from Aug 2007) →