2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
(Click here)


2. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


3. REMOVE STARTER ASSEMBLY

  1. A126954
    Disconnect the starter connector.

  1. Open the terminal cap, remove the nut, and disconnect the starter wire.

  1. A126955
    Remove the 2 bolts and starter.


4. DISCONNECT WIRE HARNESS

  1. C134973
    Disconnect the park/neutral position switch connector.

  1. Disconnect the transaxle wire connector.

  1. Disconnect the 2 speed sensor connectors.

  1. Disconnect the wire harness clamps.


5. DISCONNECT OIL COOLER TUBE SUB-ASSEMBLY

  1. C133996
    Disconnect the oil cooler outlet hose from the oil cooler tube and transaxle.

  1. Remove the bolt and oil cooler tube.


6. DISCONNECT OIL COOLER OUTLET HOSE
  1. Disconnect the oil cooler outlet hose from the transaxle.


7. DISCONNECT OIL COOLER INLET HOSE

  1. C133997
    Disconnect the hose from the transmission oil filler tube and transaxle, and remove it.


8. REMOVE REAR ENGINE MOUNTING BRACKET

  1. C134976
    Remove the 3 bolts and mounting bracket.


9. REMOVE FRONT ENGINE MOUNTING BRACKET

  1. C134977
    Remove the 4 bolts and mounting bracket.


10. REMOVE ENGINE MOUNTING BRACKET LH

  1. C134978
    Remove the 4 bolts and mounting bracket.


11. REMOVE TRANSFER ASSEMBLY

C126622
  1. Remove the 6 nuts, 2 bolts and transfer from the transaxle.


12. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

  1. D030471E01
    Remove the 2 bolts and flywheel housing under cover.

  1. D030472E01
    Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.

  1. C136364
    Remove the 3 lower side mounting bolts.

  1. C134974
    Remove the 7 upper side mounting bolts.

  1. Separate and remove the automatic transaxle.


13. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

  1. C134979
    Remove the ATF dipstick.

  1. Remove the bolt and oil filler tube.


14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

  1. C134980
    Remove the 2 bolts and cable bracket.


15. REMOVE AUTOMATIC TRANSMISSION CASE PROTECTOR
  1. Remove the 2 bolts and protector.


16. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY
← COMPONENTS (from Aug 2007)INSTALLATION (from Aug 2007) →