2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
  1. for 1AZ-FE:
    Remove the engine with transaxle (Click here).

  1. for 2AZ-FE:
    Remove the engine with transaxle (Click here)


2. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }


3. REMOVE STARTER ASSEMBLY

A124920
  1. Disconnect the starter connector.

  1. Open the terminal cap, and remove the nut and disconnect the starter wire.

  1. C127843
    Remove the 2 bolts and starter.


4. DISCONNECT WIRE HARNESS

C127821
  1. Disconnect the park/neutral position switch connector.

  1. Disconnect the transaxle wire connector.

  1. Disconnect the 2 speed sensor connectors.

  1. Disconnect the wire harness clamps.


5. REMOVE TRANSMISSION OIL COOLER (w/ Warmer)
  1. Remove the oil cooler (Click here).


6. REMOVE TRANSMISSION OIL COOLER HOSE AND TUBE (for Water Cooled)
  1. Remove the oil cooler hoses and tube (Click here).


7. REMOVE ENGINE MOUNTING BRACKET RR

C130913
  1. Remove the 3 bolts and mounting bracket.


8. REMOVE ENGINE MOUNTING BRACKET FR

C130912
  1. w/ Warmer:
    Remove the 4 bolts and mounting bracket.

  1. C130924
    for Water cooled:
    Remove the 3 bolts and mounting bracket.


9. REMOVE ENGINE MOUNTING BRACKET LH

C129380
  1. Remove the 3 bolts and mounting bracket.


10. REMOVE TRANSFER ASSEMBLY

C126622
  1. Remove the 6 nuts, 2 bolts and transfer from the transaxle.


11. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

C127819
  1. Remove the flywheel housing under cover.

  1. Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.

  1. C127820
    Remove the 4 lower side mounting bolts.

  1. C127822
    Remove the 5 upper side mounting bolts.

  1. Separate and remove the automatic transaxle.


12. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

C133010E01
  1. Remove the ATF dipstick.

  1. Remove the bolt and oil filler tube.


13. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

C133011E01
  1. Remove the 2 bolts and cable bracket.


14. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY
← REMOVAL (Jan 2007 – Jul 2007)INSTALLATION (Nov 2005 – Dec 2006) →