2005-2008 RAV4 · Service Manual SECURITIES

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CRANK ENGINE FOR MORE THAN 10 SECONDS
      NEXT

      4.CHECK FOR DTC*
      1. Check for DTCs and make a note of any codes that are output (Click here).

      2. Clear the DTC.

      3. Recheck for DTCs. Based on the DTC output in the first step, try to cause the output of the same SFI system DTC, ECD system DTC or engine immobiliser system DTC by simulating the original activity indicated by the DTC.

        Result: 
        Result
        Proceed to
        DTC output does not reoccur
        A
        SFI system DTC output reoccurs
        B
        ECD system DTC output reoccurs
        C
        Engine immobiliser system DTC output reoccurs
        D


      B.

      C.

      D.
      A

      5.PROBLEM SYMPTOMS TABLE
        Result: 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B

      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here)

      2. Terminals of ECU (Click here)

      3. Inspection (Click here)

      NEXT

      7.ADJUST, REPAIR OR REPLACE
        NEXT

        8.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2005 – Dec 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2007) →