2005-2008 RAV4 · Service Manual SECURITIES

B2762 Intrusion Sensor Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The intrusion sensor (built into the overhead junction block) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a malfunction is detected in the IOUT - IOUT line, the theft warning ECU outputs this DTC.
DTC No.
DTC Detection Condition
Trouble Area
B2762
After normal / trouble signal is output from intrusion sensor as result of self-diagnosis, following malfunctions are detected:
  1. Intrusion communication line is open
  2. Reception of signals other than normal / trouble signals
  1. Wire harness
  2. Overhead junction block (intrusion sensor)
  3. Theft warning ECU

WIRING DIAGRAM

B132256E01

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (OVERHEAD JUNCTION BLOCK - THEFT WARNING ECU AND BODY GROUND)
B132258E01
  1. Disconnect the R8 junction block connector.

  1. Disconnect the E83 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R8-4 (IOUT) - E83-8 (IOUT)
    Below 1 Ω
    R8-7 (GND) - Body ground
    R8-4 (IOUT) or E83-8 (IOUT) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. CHECK OVERHEAD JUNCTION BLOCK (OPERATION)
  1. Temporarily replace the overhead junction block (intrusion sensor) with a new or normally functioning one (Click here).

  1. Check for a DTC.

    OK:
    DTC B2762 is not output.



NG
REPLACE THEFT WARNING ECU
OK

END (INTRUSION SENSOR IS DEFECTIVE)


← B2761 Intrusion Sensor Internal Circuit Malfunction (from Nov 2005)B2763 Intrusion Sensor +B Circuit Malfunction (GND Short) (from Nov 2005) →