B2761 Intrusion Sensor Internal Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The intrusion sensor (built into the overhead junction block) conducts a self-diagnosis immediately after the power is supplied to the sensor (when the theft deterrent system is set).If a malfunction is detected in the intrusion wave transmission or wave reception, or the intrusion sensor wave transmission or wave reception circuit, the intrusion sensor sends a signal to the theft warning ECU. The ECU then outputs this DTC.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2761 |
Intrusion sensor outputs signal for sensor malfunction |
|
INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Clear the DTC (Click here)
Set the theft deterrent system and check for a DTC.
- OK:
- DTC B2761 is not output.
|
|
||||
| NG | |
| 2. CHECK OVERHEAD JUNCTION BLOCK (OPERATION) |
Temporarily replace the overhead junction block (intrusion sensor) with a new or normally functioning one (Click here).
Check for a DTC.
- OK:
- DTC B2761 is not output.
|
|
||||
| OK | ||
| ||
