B2343 Position Initialization Incomplete
Diagnostic trouble codes · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
DESCRIPTION
This DTC is output when the sliding roof drive gear (sliding roof ECU) has not been initialized.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2343 |
Sliding roof drive gear (sliding roof ECU) has not been initialized |
|
WIRING DIAGRAM
Refer to DTC B2341 (Click here).INSPECTION PROCEDURE
| 1. INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) |
Check that the sliding roof drive gear can be initialized (Click here).
- OK:
- Sliding roof drive gear can be initialized.
|
|
||||
| OK | |
| 2. CHECK SLIDING ROOF FUNCTION |
Check the auto operation with the SLIDE OPEN and TILT UP switch (Click here).
- OK:
- Auto operation operates normally with SLIDE OPEN and TILT UP switch.
|
|
||||
| OK | ||
| ||
| 3. CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - OVERHEAD JUNCTION BLOCK) |
Disconnect the R9 ECU connector.

Disconnect the R8 junction block connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
R9-7 (DWN) - R8-9 (DOWN)
Below 1 Ω
R9-9 (UP) - R8-8 (UP)
Below 1 Ω
R8-7 (GND) - Body ground
Below 1 Ω
R8-9 (DOWN) - Body ground
10 kΩ or higher
R8-8 (UP) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT OVERHEAD JUNCTION BLOCK (SLIDING ROOF CONTROL SWITCH) |
Remove the overhead junction block.

Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
8 (UP) - 7 (GND)
TILT UP switch pushed
Below 1 Ω
8 (UP) - 7 (GND)
TILT UP switch not pushed
10 kΩ or higher
9 (DOWN) - 7 (GND)
SLIDE OPEN switch pushed
Below 1 Ω
9 (DOWN) - 7 (GND)
SLIDE OPEN switch not pushed
10 kΩ or higher
|
|
||||
| OK | ||
| ||
