2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Wiper and Washer Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit detects the state of the windshield wiper switch (wiper and washer switch) and sends it to the auto wiper relay.

WIRING DIAGRAM

E124994E01

INSPECTION PROCEDURE


1. INSPECT WINDSHIELD WIPER SWITCH (FRONT WIPER SWITCH AND FRONT WASHER SWITCH)
  1. Remove the windshield wiper switch.

  1. E144464E04
    Measure the resistance of the switch.

    Standard resistance:
    Front wiper switch 
    Tester Connection
    Switch Connection
    Specified Condition
    E13-3 (+1) - E13-2 (+B)
    MIST
    Below 1 Ω
    LO
    E13-3 (+1) - E13-1 (+S)
    OFF
    AUTO
    E13-9 (AUTO) - E13-10 (E)
    E13-2 (+B) - E13-4 (+2)
    HI

    Front washer switch:
    Tester Connection
    Switch Connection
    Specified Condition
    E12-2 (EW) - E12-3 (WF)
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher



NG
REPLACE WINDSHIELD WIPER SWITCH
OK


2. CHECK WIRE HARNESS (SWITCH - RELAY, BATTERY AND BODY GROUND)
E124995E02
  1. Disconnect the E12 and E13 switch connectors.

  1. Disconnect the E66 relay connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E13-2 (+B) - E66-12 (IG)
    Below 1 Ω
    E13-3 (+1) - E66-1 (+2S)
    E13-4 (+2) - E66-3 (+2)
    E13-1 (+S) - E13-11 (+SSW)
    E13-9 (AUTO) - E66-17 (CI)
    E13-10 (E) - E66-16 (C0)
    E13-7 (VR1) - E66-7 (VR1)
    E13-8 (VR2) - E66-6 (VR2)
    E12-3 (WF) - E66 -4 (W)
    E12-2 (EW) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Wiper Motor Power Source Circuit (from Nov 2005)Rain Sensor Circuit (from Nov 2005) →