2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Wiper Motor Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit provides power to the windshield wiper motor.

WIRING DIAGRAM

E124990E01

INSPECTION PROCEDURE


1. INSPECT FUSE (WIP)
  1. Remove the WIP fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT IG1 RELAY
B137115E01
  1. Remove the IG1 relay from the instrument panel junction block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)



NG
REPLACE IG1 RELAY
OK


3. CHECK WIRE HARNESS (MOTOR - BATTERY AND BODY GROUND)
E112829E02
  1. Disconnect the A8 motor connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A8-2 (B) - Body ground
    Ignition switch on (IG)
    10 to 14 V

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    for LHD 
    Tester Connection
    Specified Condition
    A6-4 (E) - Body ground
    Below 1 Ω

    for RHD:
    Tester Connection
    Specified Condition
    A6-5 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Front Wiper Motor Circuit (from Nov 2005)Wiper and Washer Switch Circuit (from Nov 2005) →