2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Front Wiper Motor Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The auto wiper relay controls the front wiper motor.

WIRING DIAGRAM

E124938E01

INSPECTION PROCEDURE


1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
E124701E04
  1. Check windshield wiper motor operation.

    1. Remove the windshield wiper motor (Click here).

    2. Apply battery voltage to the wiper motor connector and check the operation of the wiper motor.

      OK:
      for LHD 
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (+2)
      Battery negative (-) → Terminal 4 (E)
      Motor operates at HI speed
      Battery positive (+) → Terminal 5 (+1)
      Battery negative (-) → Terminal 4 (E)
      Motor operates at LO speed

      for RHD:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (+2)
      Battery negative (-) → Terminal 5 (E)
      Motor operates at HI speed
      Battery positive (+) → Terminal 1 (+1)
      Battery negative (-) → Terminal 5 (E)
      Motor operates at LO speed

  1. E124702E04
    Check automatic stop operation.
    1. Connect the battery's positive (+) lead to terminal 5*1 or 1*2 (+1) and the negative (-) lead to terminal 4*1 or 5*2 (E). With the motor rotating at low speed (LO), disconnect the 5*1 or 1*2 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Using SST, connect terminals 5 (+1)*1 or 1 (+1)*2 and 1 (B)*1 or 3 (B)*2. Then connect the battery's positive (+) lead to terminal 2 (B) to restart the motor operation at low speed (LO).

    3. B137033E01
      Check that the motor stops automatically at the automatic stop position.

      OK:
      Motor stops automatically at the automatic stop position.



NG
REPLACE WINDSHIELD WIPER MOTOR ASSEMBLY
OK


2. CHECK WIRE HARNESS (MOTOR - RELAY AND BODY GROUND)
E124959E01
  1. Disconnect the A8 motor connector.

  1. Disconnect the E66 relay connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    for LHD 
    Tester Connection
    Specified Condition
    A8-5 (+1) - E66-2 (+1)
    Below 1 Ω
    A8-3 (+2) - E66-3 (+2)
    A8-1 (+S) - E66-10 (+SM)
    A8-4 (E) - Body ground

    for RHD:
    Tester Connection
    Specified Condition
    A8-1 (+1) - E66-2 (+1)
    Below 1 Ω
    A8-4 (+2) - E66-3 (+2)
    A8-3 (+S) - E66-10 (+SM)
    A8-5 (E) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← TERMINALS OF ECU (from Nov 2005)Wiper Motor Power Source Circuit (from Nov 2005) →