REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE, 2AZ-FE) |
 |
Remove the air cleaner case (Click here).
- HINT:
- Refer to the procedures from the removal of the purge VSV up until the removal of the air cleaner case.
| 3.
REMOVE AIR CLEANER BRACKET (for 2AD-FTV, 2AD-FHV) |
 |
Remove the air cleaner bracket (Click here).
- HINT:
- Refer to the procedures from the removal of the air cleaner cap sub-assembly up until the removal of the air cleaner bracket.
| 4.
DRAIN BRAKE FLUID |
 |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 5.
DISCONNECT BRAKE LINES |
 |
- Using SST, disconnect the 6 brake lines from the actuator.
- SST
- 09023-00101
- Place tags or marks to identify the installation locations of each brake line.
| 6.
REMOVE ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET |
 |
- Pull the lock lever upward and disconnect the connector.
- Disconnect the brake tube clamp from the bracket.
- Remove the 3 nuts and actuator with bracket.
- NOTICE:
- Be careful not to damage the brake tubes.