2005-2008 RAV4 · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for 2GR-FE)

  1. A173728
    Disconnect the mass air flow meter connector.

  1. Disconnect the VSV (air intake control) connector.

  1. Disconnect the 2 wire harness clamps and 2 vacuum hoses.

  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Loosen the No. 1 air cleaner hose clamp.

  1. Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE)
  1. Remove the air cleaner case (Click here).

    HINT:
    Refer to the procedures from the removal of the purge VSV up until the removal of the air cleaner case.


4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE)
  1. Remove the air cleaner case (Click here).

    HINT:
    Refer to the procedures from the removal of the purge VSV up until the removal of the air cleaner case.


5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2GR-FE)
  1. Disconnect the harness clamp.

  1. A137898
    Remove the 3 bolts and air cleaner case.


6. REMOVE AIR CLEANER BRACKET (for 2AD-FTV)
  1. Remove the air cleaner bracket (Click here).

    HINT:
    Refer to the procedures from the removal of the air cleaner cap sub-assembly up until the removal of the air cleaner bracket.


7. REMOVE AIR CLEANER BRACKET (for 2AD-FHV)
  1. Remove the air cleaner bracket (Click here).

    HINT:
    Refer to the procedures from the removal of the air cleaner cap sub-assembly up until the removal of the air cleaner bracket.


8. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


9. DISCONNECT BRAKE LINES

  1. C127315
    Using SST, disconnect the 6 brake lines from the actuator.
    SST
    09023-00101  

  1. C127316E01
    Place tags or marks to identify the installation locations of each brake line.


10. REMOVE ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET

  1. C127317
    Pull the lock lever upward and disconnect the connector.

  1. C128743
    Disconnect the brake tube clamp from the bracket.

  1. C127318
    Remove the 3 nuts and actuator with bracket.

    NOTICE:
    Be careful not to damage the brake tubes.

← REMOVAL (Jan 2007 – Jul 2007)REMOVAL (from Aug 2008) →