2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

Brake Actuator (Skid Control ECU) Communication Stop Mode

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
BRAKE ACTUATOR (SKID CONTROL ECU) COMMUNICATION STOP MODE
  1. ABS/VSC/TRC is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "BRAKE ACTUATOR (SKID CONTROL ECU) COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside brake actuator (skid control ECU)
  2. Brake actuator (skid control ECU) branch wire and connector
  3. Brake actuator (skid control ECU)

HINT:
For vehicle with ABS only.


WIRING DIAGRAM

C132261E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch OFF before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned OFF, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned OFF, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (BRAKE ACTUATOR BRANCH WIRE)

  1. C128164E01
    Disconnect the A27 brake actuator (skid control ECU) connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-6 (CANH) - A27-5 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO BRAKE ACTUATOR (CANH, CANL)
OK


2. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)

  1. C128164E02
    Disconnect the A27 brake actuator (skid control ECU) connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A27-2 (GND1) - Body ground
    Below 1 Ω
    A27-24 (GND2) - Body ground
    Below 1 Ω

  1. Measure the resistance of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-25 (IG1) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR (SKID CONTROL ECU)


← B2326 CAN MS Bus Line Communication Malfunction (from Nov 2005)ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode (Nov 2005 – Jul 2008) →